Skip to main content

Reboots while scanning restore image during setup

Thread needs solution

I've been restoring an image to over 100 computers using Acronis B&R 11.5.

Everything has worked as expected except for 3 computers where Acronis reboots every time after I pass the "Data to recover selection" screen where I check off the MBR and Partitions to restore.

After I press OK here the next screen loads (where one makes the final partition selections for source and destination). While the image is being scanned the system reboots without fail on these 3 machines.

I have used a refreshed copy of the bootable Acronis software. This and the image have worked on other computers. As far as I can tell there isn't a specific hardware issue with these computers as they have performed without problem previously.

Any advice on how to troubleshoot this would be appreciated. Thanks

0 Users found this helpful

Are the 3 PCs the same specifications and hardware as the ones that don't have the problem?