Recovery media and Controllerdrivers

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 2
Comments: 0

Hi,

got problems. Linux Version doesn`t now all Controllers.

PE doesn`t load drivers via programm, but often via drvload.

Loading some drivers, like adaptev 6405, causes resart of PE.

Creating PE via Acronis Mediabuilder an load drivers within doesn`t work at all.

Testet with areca drivers and adaptec 5x,6x drives. PE Win7 and Win 10

Hints?

K.G.

Fri, 08/19/2016 - 07:41
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Member
Posts: 24
Comments: 31

Hello,

Years ago I ran into a similar problem and was advised to use the Windows PE version.

I created the Windows PE version and got the recovery media to work, but it gave off a lot of warnings of problems.

Eventually they added the driver I needed to the Linux version and so I stuck with that because the backups and restores completed without any error messages or warnings.

So, I also would like to know how we can either add a hard disk controller driver to the Linux version or the Windows PE version and get full functionality from the Recovery Media without Error Messages or Warnings.

Sun, 08/28/2016 - 00:05