How to replicate the latest backup to another location

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 4

Hello,

is there any built-in solution to replicate the latest backups to another location after the backup has been created?
I know, that it is possible to replicate to other locations within a backup job, but backing up 20 VMs per night takes about 5 hours with lots of errors, if we enable replication. Without replication the same job runs about 20 minutes...
I have seen the possibility to export a whole archive-set via cmdline, but I only need the latest backup from an archive.

Any ideas?

Mon, 06/03/2013 - 07:32
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 4

Hello elenal,

thanks for the reply, but we are looking for a solution to export only the latest backup and not the entire archive.

Wed, 07/10/2013 - 07:32
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Regular Poster
Posts: 0
Comments: 177

There are two export commands: "export archive" and "export backup". You are talking about the 1st one. I am talking about the 2nd. See its description: If the --backup parameter is not specified, the command will export only the latest backup.

Wed, 07/10/2013 - 22:08