Re-enabling an Alert

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 4
Comments: 7

Having fits with a backup. It can't run it it quite mode. I use to get a popup "Error Reading Sector XX from DIsk 1" and which point if I answered "Ignore All:" the backup would finish.

Then I hit "don't show this again". I need to show it again get get the backup working. How do I re-enable it to it pops-up again?

Wed, 12/06/2017 - 13:35
0 Users found this helpful