Skip to main content

ABR11 - No progress indicator during basic disk clone

Thread needs solution

I have just upgraded to ABR11 and created a new bootable USB pen from the Bootable Media Builder. I have just booted from it and tried a basic disk clone on 2 different PCs and each time, once I commit the change and click proceed, the screen reverts back to the disk managament screen and no progress indicator is shown. I know the cloning process is happening due to activity on the HDD light, and the only way to tell when it's complete is to wait until the light stops flashing.

Is this a known problem with ABR11? It was fine with ABR10.

0 Users found this helpful

Hello Chris,

Thank you for posting. I will do my best to assist you.

I checked our system and did not find any known issues with cloning. I will forward this problem to our Testing Lab and just in case I may need to get back to you and ask for additional diagnostic information.

If you have additional questions please let me know.

Thank you.

Hello Chris,

I have an update about this issue. It is possible it is related to your specific environment that is why I would appreciate if you could contact our Support team with this report collected the following way:

 - Launch the cloning wizard and let it run for some time. Then collect the report.

Please let me know if you have additional questions.

Thank you.