acronis Backup & Recovery mount point question

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 1

Greetings~

I am evaluating Backup & Recovery , I recreated an image with ATIM 2011, but I cannot mount as driver, I could only set mount point which is a folder. If I do that, it could mount as driver (assign letter ) but unmount also bring the driver away.....

Could someone give a try?

Fri, 12/16/2011 - 03:31
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Star
Posts: 27
Comments: 1940

Can you post the screenshot of help->about window (with serial number removed/obscured, of course) ?

Sat, 12/17/2011 - 07:43
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 1

Sorry, I unistalled the pruduct to install ATIM 2011/2012, I will reinstall ABR later on.

Good luck~

Sat, 12/17/2011 - 08:15