Cannot find dual destination for my backup

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 2
Comments: 1

I don't understand what's going on... I'm trying to create a new task to backup some specific directories. All appears to be fine, except that I cannot see the option to select a dual destination under Options (right below Error handling).

Note that I have a different full backup task (disks/volumes) where "dual destination" is visible (I just don't need to use it for this backup).

Using what I believe is the latest build: 10.0.13762

What gives?

Thanks,

Andrei

Tue, 02/04/2014 - 20:28
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 2
Comments: 1

I figured it out - dual destination only shows up if the primary destination is not a network appliance (a NAS). So in my case, it showed up when I selected a USB drive.

Now I'm having another problem, thank you very much - failed to create the backup plan (when saving). The system cannot find the file specified.

Tue, 02/04/2014 - 21:14