Do you need to add the HAL drivers in B & R 10?

So i have B & R 10 with UR.

But i was reading this article on an older version of B & R which says you MUST add the HAL drivers during the restore,

http://cheelam.com/blog/wp-content/uploads/2009/04/hal.png
http://cheelam.com/blog/2009/04/01/acronis-true-image-universal-restore…

Do you still need to do this in B & R 10 with UR or does the latest version already do this for you.

Reason i am asking is because i tried to restore an image on an older PC (so dissimilar Hardware) but got a BSOD error 0x0000007b etc which i think meant the correct mass storage drivers weren't installed.

But i thought UR took care of this, what is the point of UR if you have to add drivers anyway?

And i had the UR option as "use" during the restore.

I also successfully restored this same image of other dissimilar PC's so just one PC so far that gave a BSOD.

I didn't add any additional drivers (folders) during the restore all i did was set UR to "use" so i think what is happening is that i am just doing a standard "hot swap" image restore with no "magic", HAL etc from UR is being used.

Any ideas??