Problem in backing up QNX4 partition

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 4
Comments: 6

Hello.

I wish to use Acronis Backup & Recovery to backup a QNX4 partition on a PC. I wish to do a sector-by-sector backup of the partition to a sufficiantly big USB stick.

The partition is only 8Gb is size. No other partitions exist on the HDD.

When I boot using Acronis, it doesn't even detect and HDD partitions. When I look to see the different partitions, it says that no disk has been detected, and that there is nothing to display.

I am able to see the USB stick I intended to use as a target destination, but this is not what I want to backup.

Any help so that I can see the QNX4 partition, if it is possible, would be much appreciated.

Stéphane.

Wed, 11/30/2011 - 15:25
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Star
Posts: 27
Comments: 1940

If it doesn't see the disk, it looks like hardware compatibility problem. (Does it see the disk in navigation->disk management? ). If latest update doens't help, you may try WinPE-based bootable media ( http://kb.acronis.com/content/24254 ) If Vista or Windows 7 install CD sees the disk, this should work without iinjecting additional drivers to WinPE media.

Wed, 11/30/2011 - 17:59
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 4
Comments: 6

After further tests, it does appear to be a hardware issue. i will change the HDD and test further.
Thanks for the assistance.

Thu, 12/01/2011 - 08:29