Restore or clone to a particular drive connection

I would like to be able to set up a job to restore an image to the drive plugged into a particular USB port or SATA port, without having to modify the job each time to locate the destination drive. The drives will be plugged in and removed while Windows is still running, without rebooting. For example, I may want to restore the same image to several drives which will consecutively be plugged into the same port. I would like to be able to save as part of the restore job the fact that the drive is connected to a particular port so that I could run the same job over and over again without modifying it to locate the destination drive each time I plug in a new drive. Is there a way to do this?

Similarly, I want to make a job that will clone from one drive to another without having to locate the drives each time. The drives might be different models each time I run the job. The thing that will remain the same is that the source drive will always be plugged in to the same port each time and the destination drive will always be plugged in to the same port each time. Is there a way to do this?