Skip to main content

Status after recovery "Error"

Thread needs solution

1. I just recovered my systen-partition with automatic reboot. After recovering the status shows "Error" in the backup plan. That's definitely wrong, all went ok with restoration and it should display "Succeeded".

2. I always get a "Warning" status if i run a tape-based backup plan with automatic overwriting of the tape. Why? If i set up in the options, that i want to rewrite the tape automaticly there should be no "Warning" status, because that's ok.

Forellenblau

0 Users found this helpful

1 - The error is about the backup plan, not the restore task. You restored the system to the point when corresponding backup task was just started. When the snapshot was taken during the backup creation, backup plan was in 'running' state, and when backup process was completed, it was marked as succeeded, but the backup was already created with 'running' state in the list of backup tasks. After booting, it discovers backup plan with 'running' state and no corresponding process - as if the system was repbooted while performing the backup.