timntr_2k.sys not found during ABR11 installation.

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 6
Comments: 7

When installing ABR11 I get this message.

I followed the procedure in the KB where the oemxx.inf is removed.
But.. when I install ABR11 again this inf file is there again.

So, it seems that the procedure to remove the inf file is not enough.

How can I install ABR11 ?

Tue, 12/20/2011 - 14:48
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 6
Comments: 7

Seems solved.

Found the timntr_2k.sys in the ABR Management Console.msi.
Extracted it and informed ABR during the install where to find it.... installation succesful.

Tested it with ABR10 and ABR11, works.

I'm a bit disappointed about the KB on this subject.

The articles found in the KB mentioned this problem being caused by 'previous' ABR installations only.

To my opinion the cause of the problem is in the ABR installer / lack of unpacking the timntr_2k files.

Bas

Wed, 12/21/2011 - 11:52