Skip to main content

Odd Clone Failure

Thread needs solution

I have Acronis Cyber Protect Home Office (True Image Version 2021), Build 40173 on a Windows 10 desktop with all Acronis and Windows updates.

This problem has happened before. I started the clone process, select Automatic mode and I did the usual processes of selecting the source and destination disks. I then indicated that the disk would replace a disk on the source computer.

I selected Proceed and after about 1or 2 seconds,  the Disk Cloning Process dialog box came up saying “The disk was successfully cloned”. However, nothing was copied to the destination disk. This happened several times.

Perhaps the issue is that the hard drive is a 953 GB PCIe SSD that is directly attached to the motherboard via a NVMe interface and not connected with a traditional cable. The destination  hard drive uses a traditional HD cable connected to the mother board..

Also the first partition on C: which is the source HD has a 100 MB Healthy (EFT System Partition) the C: partition is the second partition on the HD. The third partition is a 508 MB Healthy (recovery Partition)

Suggestions to fix this???

I can be reached at    wwpearce@comcast.net        

 

1 Users found this helpful

Duplicate of topic: Clone Failure