Skip to main content

Ziel-Laufwerk wird nicht gesehen

Thread needs solution

Ein mit Acronis erstelltes Image soll auf ein neues Notebook übertragen werden. Zuvor wurde vom neuen Notebook ein Image gefertigt und auf einen externen Datenträger gespeichert. Danach wurde das Recovery des auf dem externen Datenträger gespeicherten Images eingeleitet. Das externe Image wurde geprüft und dann soll das Ziellaufwerk gewählt werden. Das Ziellaufwerk wird jedoch nicht gesehen und kann daher nicht ausgewählt werden. Acronis wurde von einem USB Stick gestartet. Was man auch im BIOS ändert, die interne M.2 Platte des Notebooks wird nicht gesehen.

Was kann das sein?

Gruß

Lothar

0 Users found this helpful

An image created with Acronis is to be transferred to a new notebook. Beforehand, an image was made of the new notebook and saved on an external data carrier. Then the recovery of the image stored on the external data medium was initiated. The external image has been checked and then the target drive should be selected. However, the target drive is not seen and therefore cannot be selected. Acronis was started from a USB stick. No matter what you change in the BIOS, the internal M.2 disk of the notebook is not seen.

What could that be?

What version of Acronis are you using here? Is it ACPHO or an older ATI version.

What system was the image create from that you are trying to transfer to the new notebook?

Does that source system have a NVMe M.2 SSD installed in it?

I would recommend installing Acronis on the new notebook then creating the 'Simple' version of bootable rescue media which will use the Windows Recovery Environment to provide device drivers needed for the M.2 SSD.  The use that media to try booting the new notebook and check that the M.2 SSD is seen to allow for a transfer / restore / recovery.

KB 59877: Acronis True Image: how to distinguish between UEFI and Legacy BIOS boot modes of Acronis Bootable Media

KB 69472: Acronis Cyber Protect Home Office: how to create bootable media

KB 69427: Acronis Cyber Protect Home Office: How to restore your computer with WinPE-based or WinRE-based media