Disk Director does not recognize OCZ IBIS SSD. How to clone HDD to IBIS SSD?

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 0

I have installed an OCZ IBIS 240Gb SSD drive. I want to move all partitions on my 1TB HDD to the new SSD drive. I used Disk Director 11 to resize the 920GB partition down to 150GB. After the resize, the system would not startup without rebooting. However, when I recovered the partition using Dell DataSafe, it started up and is working properly ... plus it's now sized to 150GB. Now I'm ready to clone the HDD partitions to the SSD drive. However, it seems that Disk Director does not recognize the IBIS drive. Is this a problem with Disk Director? Is there a service release for this?

Windows Disk Management can see the drive and I was able to format it. In order for Windows to see the drive, I had to load the "Silicon Image SiI 3124 SoftRaid 5 Controller" drivers.

How can I get Disk Director to clone the HDD to the IBIS SSD?

Thanks,
Gary.

Wed, 03/09/2011 - 07:32
0 Users found this helpful