Skip to main content

Build 1666 looping on laptop when trying to push an image- **I need more Deployment licenses.**

Thread needs solution

Whenever I get to the point of the image to start to deploy , the laptop loops back to the point to getting the dhcp address in the Acronis Agent section and then tries to lay the image down again. It does this over and over. Tried it with all different hardware and images. Last time this happened I rebooted and that seemed to fix it. This time no amount of reboots or service restarts help.

 

 

Attachment Size
acronis.jpg 119.07 KB
0 Users found this helpful

just saw your screenshot...

you sure you have a valid license? You're using a pc deployment... those are tied to the bios firmware of each system. If you had 10 licenses and deployed 10, but wanted to do 11, you'd have to buy more pc deployment licenses. That is usually why you'd see that message.

If you're sure you have a valid license, how long ago did you upgrade to 1666? Can you deploy to other systems that you deployed to before? If not, it could be pxeboot. Remove the pxe component, reboot, and install just pxe agsin. Reboot and try again.

 

Deployed 1666 about a month ago. Ran into a problem of not seeing the NIC. Reinstalled PXE component and it worked. Can't deploy older builds either. Licence is valid, just shows 100/100 used. It's been saying that though. I might reinstall PXE one more time.

Reinstalled the PXE component to be safe. Same problem and same error log. Looks like we need to purchase more licenses. 

Yup, if you've used them all up, you pretty much have to grab another for each new system. If you fave a per pc license though, you can use it for unlimited deployments to those systems though.