Skip to main content

Deployment fails at startup on HP Workstation Z230 using mirro disk raid

Thread needs solution

Hi All

I have with Succes created an image of the Workstation, that is no problem.
I can also without any problems deploy the image, to a new Workstation.

The problem starts when i start up the Workstation.
When booting Windows, Windows enters a bootloop or reports operating system not present, depending on how i have made the initial image.

I have tried to inject stage drivers, and search for the storage driver, no matter the option used, the two scenarios above is the result.

Du you have any ideas ?

0 Users found this helpful

Hello Thomas,

thank you for your posting.

As far as I understand you are deploying image to a dissimilar hardware and the described behaviour most likely indicates that drivers for boot devices were not successfully updated.

Please carefully follow all the steps in this guide (note that if the target hardware has a specific mass-storage controller you need to explicitly specify the appropriate driver for that controller as in step three) and let me know the results.

Thank you.