Skip to main content

Deployment Failure

Thread needs solution

Hi Guys,

Recently built a 2012 Windows Server for Acronis. I was able to create an image fine, when I tried to deploy the same image Acronis cuts off after like 30 seconds and goes back to snap deploy screen. Not sure whats going on.

Host '10.0.251.141' has failed the deployment.
Additional info: 
--------------------
Error code: 1
Module: 52
LineInfo: 6934824D6BD2F69E
Fields: $module : "osd_server_vs_1660"
Message: Host '10.0.251.141' has failed the deployment.
--------------------
Error code: 32
Module: 7
LineInfo: F5F8CBCF76155663
Fields: $module : "osd_server_vs_1660"
Message: The archive is corrupted.

0 Users found this helpful
frestogaslorastaswastavewroviwroclolacorashibushurutraciwrubrishabenichikucrijorejenufrilomuwrigaslowrikejawrachosleratiswurelaseriprouobrunoviswosuthitribrepakotritopislivadrauibretisetewrapenuwrapi
Posts: 250
Comments: 7092

Hello Danny,

Thank you for your posting! 

  • First of all I would check the image integrity by validating it. If validation fails, please diagnose the master system with chkdsk and create new image after all errors are repaired;
  • If the issue persists, let's move the master image to the different location. If the master image is located on the network, try to exclude this point of failure by copying the master image to a local drive of the Deploy Server.
  • As a quick workaround if the deployment is urgent and as a test to exclude network issues, please try to run a Standalone Deployment.

Thank you,