Snap Deploy 5 not detecting Crucial MX200 in Dell Latitude E6520 (Error E000101F4)

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 1

I'm trying to use snap deploy 5 to deploy an image onto 10 laptops (Dell Latitude E6520) with recently upgraded 250GB Crucial MX200 solid state drives. When I boot using the normal media OR the WinPE media I get the error E000101F4 and I'm told that there are no disks that can be imaged. The drives show up in the bios (which is up to date) and they show up when I do a manual install of Windows 7. If I swap the 250GB out with the original 128GB drives everything is fine. Any idea why these drives aren't showing up? It's obviously not a motherboard driver issue if other drives show up just fine. I've tried 3 different drives with 3 different laptops.

Help would be appreciated.

Wed, 09/23/2015 - 21:55
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Regular Poster
Posts: 0
Comments: 202

Hello,

Please clarify, the 250GB Crucial MX200 has MBR or GPT partition style?

It makes sense to try to change SATA controller more from IDE to AHCI or vice versa.

If it does not help, then I suppose that the issue has to be tested on similar environment.
Please contact our Support team http://www.acronis.com/support/

Best regards.

Fri, 10/16/2015 - 12:52