Skip to main content

ATI 2016 bugs

Thread needs solution

After a fresh install of Windows 10 64 bits Home edition, I installed Acronis True Image 2016.
No reboot of the system is asked after the installation. The I faced various problems.

Problems faced:

While creating a new backup job, the right tab of the interface was blank, with no possibility to set the backup parameters. After a restart of ATI 2016, the left tab is no longer empty.

So I created a local backup of the system partition (C:) to data drive (D:) and started the job.
An error appeared: "Partition not reachable".
I did a reboot of the computer and it failed to start after BIOS.
Apparently, ATI 2016 killed the MBR or something like that...

All data is lost and I have to start again Windows 10 installation from scratch.

0 Users found this helpful

Terrible. Perhaps the download was corrupted. Please turn to the Aronois support.

Thanks, no the download is not corrupted and the installation went smoothly and rapidly.

I did a full reinstall of both Windows 10 and ATI 2016, and I do not face the problem anymore.
The only difference is that I did a reboot of the computer after the installation of ATI 2016 before using it.