Clone win 10 error
I am running a Dual Boot system.. Windows 8.1 and Windows 10.. The system contains three WD Black 1TB drives.
1st drive: Windows 8.1
2nd drive: DATA files and other backups (simple file copies), 3rd drive: Windows 10
These drives are 7 years old and i decided to replace them before they might Fail and keep original drives as backups.
Using True Image 2016: Build 6027
The 1st drive (8.1) cloned with out issue
2nd drive (DATA) cloned without issue
3rd drive (10) failed, it copied most of the files but missed about 1GB of files)
I tried it again and it failed, all the files were copied this time but getting an error message..
-------------------------------------------------------------------------------------------------------
Failed to write data to the disk
Failed to write to sector `12,602.871` of hard disk `4`. Failed to write the snapshot
manager volume. (0x1000D3) Unknown status. (0x9) Access is denied (0xFFF0)
---------------------------------------------------------------------------------------------------------
I got this message for a large group of sectors, some random some in groups. I ran WD diagnostics on the new drive.. Drive passed 100%
All Cloning Procedures were run from Windows 8.1 where the Acronis is installed
ANY IDEAS OR COMMENTS ?


- Log in to post comments

One other note, make sure that the new drive is formatted the same as the old one too - if the old drive is MBR the new one should be MBR and vice-versa if the old one is GPT... the new one should be formatted as GPT as well.
- Log in to post comments