Skip to main content

Rescue Media says "Trial Version"

Thread needs solution

Hi,

i tried to clone a HDD to a SSD. I used the Rescue Media (not WinPE) for this. Every time i try i can slect my disks and change the partition layout. But when i'm ready with my settings and want to proceed i get a message like "Trial Version does not support this function".

But i have NO trial. I have a full paied version. I tried this procdure with the Rescue Media Builder and with the ISO File i can download in my account area. Both do the same.

Any ideas?

0 Users found this helpful

aPollO, welcome to these user forums.

What build version of ATIH 2016 do you have installed?  The current latest version is build 6589 and you should have this installed for when you create the standard (Linux based) rescue media.

There were some reports of the rescue media showing as the trial version a while back but this was resolved in the later builds.  Note: it is possible for this to happen with the WinPE version if the correct WinPE.zip is not installed.

If you still have a problem with the latest .ISO file downloaded from your Acronis account, then I would recommend opening a Support Case directly with Acronis and ask them to check the ISO file stored with your account.