Skip to main content

Win 10 Indizierung bei mit Acronis 2016 geklonter Festplatte

Thread needs solution

Habe in Microsoft Community erfolglos nach einer Lösung gesucht. Kennt Acronis eine?

Wenn ich meine Festplatte C mit Acronis auf eine zweite Festplatte klone, werden mir bei der Suche auf C nur die Resultate der zweiten Festplatte angezeigt. Ich kann bei den Indizierungsoptionen auf <ändern> drücken und alle Häckchen bei der zweiten Festplatte entfernen und solche nur bei der C-Platte setzen, es nützt nichts. Es erscheinen auch nach dem OK nur die zweite Platte als <Einbezogene Orte> und bei der Suche nur die dortigen Resultate.

Wie kann ich das verhindern?

Sie hatten diese Frage

  •  

 

DorianWD hat geantwortet am

  •  

Hallo Edomus,

Also, du hast die ganze Platte inkl. Betriebssystem geklont und jetzt sind beide Platten am Rechner angeschlossen? Habe ich das richtig verstanden? In so einem Fall sollte eine der Platten abgeklemmt bleiben, sonst können Fehler auftreten. Oder geh es hier um was Anderes?

lg

Dies als erste Person als "Hilfreich" markieren

  •  
  •  

Edomus hat geantwortet am

Danke für die Antwort. Ja - genau, beide Platten sind angeschlossen und ich kann beim Booten, wenn ich will,  über das Bios auswählen, welche starten soll. Wenn ich aber eine abhängen muss, müsste ich sie ja jedesmal bei einem erneuten Klonen wieder anhängen. Oder gibt es eine andere Methode, um sie - wie du sagst - abzuklemmen?

Gruss, Edomus

Dies als erste Person als "Hilfreich" markieren

  •  

Gibt es keine valable Lösung zum Problem?

0 Users found this helpful

Edmund, if I understand the translation of your post correctly, you have cloned your Windows OS disk drive and now have both the original drive and the cloned drive (with the second copy of the Windows OS) connected in your computer, and you are able to boot from either drive by changing the boot drive setting in BIOS.

If this is the correct case, then this is not how cloning is intended to be used - only one such disk drive should remain connected in the computer after the clone has been completed successfully.

Please see forum post: 128231: [IMPORTANT] CLONING - How NOT to do this!!! which was written because of the problems that many users were reporting in these forums.

If your intention is to want to remove one of the two disk drives connected in your computer, then I would recommend disconnecting the cloned (target) drive and checking that, with the correct BIOS settings, that you are still able to boot into Windows from the original drive without having any dependencies on the removed drive.

Thank you for your prompt answer.

Does this mean, that I have to disconnect the cable connection between motherboard and the cloned target drive - what for me is not an elegant solution - or is there a possibility to disable the target drive by commands. In my Bios I did not find such a thing...

In your furder explanations I did not find a answer for this point.

Edomus

Edomus, I do not think that it is possible to just disable the cloned target drive using any settings in the BIOS, so it is the less elegant solution that will be needed, but you should just be able to unplug the SATA cable from the target drive rather than from the motherboard end of the cable.  

Thanks again.

So I have to bite in the sour apple... Of course I disconnect the cable from the target drive...