Skip to main content

from 128 gb ssd to 480 gb ssd

Thread needs solution

Hi there,

I have clone my old ssd (128 gb) to a new ssd (480 gb). Only drive c.

The system runs, but on the new ssd (480 gb) there are only shown 119 gb and not 480 gb.

What can I do?

 

Thanks.

 

HR

0 Users found this helpful

Your scenario indicates that you used the Manual Mode to run the clone which if you do so requires that you manually enter the desire size of the resultant partition for the clone.   Had you chosen the Automatic or Proportional Mode then the clone tool would have resized the resultant partition for you.

You will need to use another third party partitioning tool such as Minitool to expand the partition to encompass the whole disk.  Or, you can run the clone tool again and choose Automatic.

Very good to hear. Enjoy!