Warum bootet PC nicht nach Einspielen eines Backups?
Dieser Tage habe ich bei einer Bekannten mit einem Windows 8.1 Rechner die SSD für die Windows-Partition C: gegen eine größere ausgetauscht. Bislang hatte ihre SSD 64 GB, eingebaut wurde von mir eine Samsung EVO 850 mit 1 TB. Zuvor wurde von mir eine gründliche Reinigung von C: mit der Windows Datenträgerbereinigung durchgeführt, schließlich noch ATIH 2017 (zunächst als Testversion) installiert und auf eine externe Festplatte ein Backup von C: gemacht. Nach dem Wechsel der SSD habe ich mit Hilfe meiner eigenen Acronis Recovery CD das Backup auf die neue SSD aufgespielt. Alles klappte hervorragend bis auf…. ja, bis auf die Tatsache, dass der PC nicht mehr bootete. Nachdem Bootversuch startete das BIOS/UEFI.
Ich kann mir das nicht erklären zumal, zumal ich dieselbe Prozedur schon bei meinem Windows 10 Rechner und bei einer Bekannten für deren neues Laptop erfolgreich durchgeführt habe. Weiß jemand Rat?
Danke für jede Unterstützung!
Klaus Hausmann


- Log in to post comments

Klaus wrote: Why does not PC boot after a backup?
This days, I have a friend with a Windows 8.1 computer the SSD for the Windows partition C: exchanged for a larger. So far had their SSD 64 GB, was installed by me a Samsung EVO 850 with 1 TB. Previously, I had a thorough cleaning of C: with the Windows data carrier cleaning done, finally still ATIH 2017 (first as a test version) installed and on an external hard drive a backup of C: made. After the change of the SSD I have the backup with the help of my own Acronis Recovery CD on the new SSD. Everything went well except for .... Yes, except for the fact that the PC no longer booted. After boot try the BIOS / UEFI.
I can not explain this, especially since I have already done this procedure already with my Windows 10 computer and with a friend for their new laptop successfully. Does someone know advice?
Thanks for any support!
Klaus, if you replace the original SSD back in the computer, does that then boot correctly?
If it does, then please check how the computer normally boots? See webpage: Check if your PC uses UEFI or BIOS for how to check.
If you are either cloning or restoring an OS backup using the Acronis Rescue Media, then it is very important that this is booted in the same boot mode as used by the OS, i.e. both using UEFI or both using Legacy.
Another point to check, in the BIOS settings, if this is a UEFI computer, that you have Windows Boot Manager set as the default boot device.
- Log in to post comments