Skip to main content

ATI 2018 Rescue Media

Thread needs solution

The rescue media used to include a link to Disk Director at one time - I have DD12 installed. Useful if a recovery fails to boot if the active red flag goes to the wrong partition and it could be corrected.

Is there any way to restore this facility?

0 Users found this helpful

You can use the MVP Custom ATI PE Builder tool which will include all installed Acronis applications in the rescue media for you.  Link below in my signature.

 

There is another (better IMO) way to achieve the above. I found on my ADD12 - Bootable Media Builder but this produced 'Error Component Not Found'.

After performing a repair of ADD12, the Bootable Media Builder functioned and I selected the Linux representation, skipped parameters and selected ATI, ASR and ADD12 all 64 bit, and skipped drivers. I then created recovery media on both a USB key and Rewritable DVD.

I tested all the recovery media satisfactorily which showed the latest ATI and ADD installed on my PC's and even went as far as a recovery.

This is satisfying as I was tempted to accept the discount offerings of ATI2019 + Free ADD12.5 which I don't believe do anything better.