Skip to main content

Laufwerk ist eingerichtet - aber explorer übernimmt die werte nicht

Thread needs solution

Musste meine c-Platte (bootpartition) vergrössern. der disk director hat das hervorragend umgesetzt. leicer erkennt windows die veränderte grösse nicht. Bei Grössenveränderungen auf d-platte habe ich kein problem. Kennt jemand das Problem?

 

0 Users found this helpful

Stefan wrote:

Drive is set up - but explorer does not take the values
Had to enlarge my c-disk (bootpartition). the disk director has done so well. leicer does not recognize windows the changed size. For size changes on d-plate, I have no problem. does anyone know the problem?

Stefan, welcome to these User Forums.

Sorry, but I am not sure that I understand the problem / question here?

It sounds that you have changed / increased the size of your Windows OS partition (C: drive) using Acronis Disk Director but that size is not recognised when you are in Windows?

Does this mean that Windows still shows the original C: drive partition size?

If yes, then it is possible that you did not fully shutdown your computer before using Disk Director, and thus you were in a Windows Fast Start = Hybrid sleep = Hibernation state and the changes to the partition were made in this state.

Try doing a full Shutdown by typing shutdown /s at the run prompt then see if this makes a difference to what is shown when you restart into Windows.  If the change is not shown still, then do the same again, then run Acronis Disk Director from its boot media and make the change again.