Skip to main content

Automatische Bereiningung funktioniert plötzlich nicht mehr

Thread needs solution

Seit über einem Jahr starte ich Aufgaben, um (jede Woche manuell starten)  ein Image von C: und eins von J: auf externe Festplatte zu sichern. Das hat seit Februar 2020 problemlos geklappt.

Aber am Sonntag wurde lediglich nach Image-Erstellung von C: wie erwartet bereinigt. Für die Image-Erstellung von J: aber nicht mehr. Beide Aufgaben wurden am 29.2.2020 erstellt und seither nicht verändert. Es wird keine Fehlermeldung erzeugt - im Logbuch fehlt ein Eintrag "XX GB wurden freigegeben" und das alte .tib ist noch da.

In "Optionen" steht fürs Automatische Bereinigen "Speichere nicht mehr als 3 neueste Version" und ein Häkchen bei "Erste  Version nicht löschen" ist auch nicht gesetzt.

Ich verwende Acronis True Image 2019 mit Windows 10.

Bem.: Mit ATI 2014 an meinem alten Notebook (Windows 8.1) funktionieren ähnliche Tasks manchmal - und seit Mitte 2020 - manchmal auch nicht! Mit ATI 2019 am neuen Notebook (Windows10) gab es bis gestern keinen einzigen Fehler.

Was kann ich noch prüfen/ändern damit ATI wieder aufräumt?

Wie ich (mit ATI) manuell bereinigen ohne die "Aufgabe zum Sichern" zu zerstören?

 

0 Users found this helpful

For over a year I have been starting tasks to save an image of C: and one of J: to an external hard drive (start manually every week). This has worked without any problems since February 2020.

But on Sunday only after image creation of C: was cleaned as expected. For image creation of J: but no more. Both tasks were created on February 29, 2020 and have not been changed since then. No error message is generated - an entry 'XX GB have been released' is missing in the logbook and the old .tib is still there.

In 'Options' stands for automatic cleaning 'Do not save more than 3 newest versions' and there is no checkmark next to 'Do not delete first version'.

I am using Acronis True Image 2019 with Windows 10.

Note: With ATI 2014 on my old notebook (Windows 8.1), similar tasks sometimes work - and since mid-2020 - sometimes they don't! With ATI 2019 on the new notebook (Windows 10) there was not a single error until yesterday.

What else can I check / change so that ATI cleans up again?

How do I manually clean up (with ATI) without destroying the 'backup task'?

Harti, you should check the backup log for your task where automatic cleanup is not working to see if this will give any more information on any errors that may prevent this?

See the Acronis Community tools link in my signature for download links to the MVP Log Viewer tool or the newer MVP Assistant  tool for looking at any of the logs produced by ATI.

See KB 61844: Acronis True Image 2019, 2020 and 2021: How to delete old backups for information on the new 'Clean up versions' tool provided in ATI 2019 and later versions for cleaning up unwanted backup files.