Skip to main content

No "Next or "Cancel" box when using Wizard for recovery

Thread solved
Beginner
Posts: 6
Comments: 4

Good Day:

When ever I recover my system using the rescue disk by clicking on "Recovery", and selecting the correct partition, there are no "Next" or Cancel" boxes to click on to allow me to proceed.  When instead of using the wizard I use the Recovery option at the top of the interface these boxes appear and I can proceed with the recovery.

Is this normal behaviour?.

0 Users found this helpful

Yes and no, it takes time for the rescue disk to scan the backup chosen for recovery and time to scan the disk selected to make the restore to.  It could be that you need to be more patient.  I have never waited more than a few minutes for these actions to complete it that helps.

I've seen this in the past too.  Instead of using the big buttons on the left side of the screen in the recovery environment, use the top drop down menu's instead if it keeps happening. That usually allows the recovery to continue where you're then able to select a recovery .tib to continue moving through the recovery steps.