Skip to main content

Backup name and validation name out of synch

Thread solved

I 'always' make full backups with validation on two drives one internal and one on the NAS. Recently on the local drive it writes a backup like MKNSSDSR500GB-Speedy_full_b556_s1_v1.tib and then tries (and fails) to validate because it is a different file name than the backup it just made. How do I get this back in synch?

0 Users found this helpful

Sorry but not enough information to understand the issue fully here?

What version of ATI is being used?  Is it ATI 2020 build 25700 per this forum?

What type of backup is this?  Disks & Partitions or Files & Folders?

There is a new log viewer tool that has now been made available by Acronis via the Community Tools KB page.  See the link in my signature for the MVP Assistant tool.

If you have Disks & Partitions backups created on ATI 2020 or later using .tibx files, then look in the Backup Worker logs.

If you have Files & Folders backups using .tib files (or Disk backup using same) then look in the Demon logs.

The logs should give more information about what is happening here and about the failure.

It was ATI 2020 build 25700 per this forum. I was making Disk & Partition backups of Drive C:

I fixed it by deleting the backup and remaking it. Thank you.