No current disk after restore
Hello,
I recently had to change my PC internal disk (SSD) for a larger one, so I installed the new SSD and did a full restore. This worked OK. Yesterday was the time for the first backup with this new SSD and I got the message "no current disk" and the link between my computer and the backup disk was "broken" (red cross instead of green check mark).
I read some posts from the forum, decided to manually add existing backups (in order not to lose them), then reconfigured the backup and did it. Worked OK.
My issue is: windows explorer shows that all my previous backups (both complete and differential) are present on my backup drive. But from Acronis, I cannot select any of them, only the brand new one is accessible. If I had to restore from the latest "old" backup, how should I proceed?
Many thanks in advance if you can help me.


- Log in to post comments

Thank you Steve for your documented answer.
I think I'll now be able to manage a new change of source disk. But at the time I did it for the first time, I really was anxious to see the broken link between my new hard disk and the previous backups.
Thanks again.
- Log in to post comments

Matteo wrote:Thank you Steve for your documented answer.
I think I'll now be able to manage a new change of source disk. But at the time I did it for the first time, I really was anxious to see the broken link between my new hard disk and the previous backups.
Thanks again.
Hello!
Thanks for updating the thread. This may help other users.
Feel free to participate in our community anytime you need.
Best regards.
- Log in to post comments