Skip to main content

Rescue media Recovery wizard UI stuck after choosing recovery source

Thread solved

I am trying to restore the system drive partition of my Lenovo T480. After booting with the pre-made USB rescue media, I locate the backup file from my backup disk and define the recovery point - which partition I'd like to restore (i.e. C:).

However, the UI subsequently goes blank and unresponsive. No button can be interacted with.

What else can I do to get the wizard going? :(

0 Users found this helpful

Aaron, how long have you waited for the panel to change?  Unfortunately ATI is pretty bad at telling the user what it is doing at that stage of the recovery and just acts dumb for a while before moving on!

Never mind by the time it took me to edit the photo and type out this question on another computer, the UI (after an awfully long time) finally kicked back alive and I was able to proceed with the rest of the recovery process.