Skip to main content

Acronis 2021, Completion bar at bottom resets to beginning when almost done (20Gbyte) remaining

Thread needs solution

Not a big deal, just irritating... the completion bar that moves during backups to completion resets to the beginning (left side) during roughly in my case 20Gbytes from completion.  Then finishes up normally, within the normal timeframesk, and all is good.  Does not effect backup, just visual picture of beginning to completion.  Just wondering if a patch might be available.  Again, no big deal, just visually irritating. Started with Acronis 2021

0 Users found this helpful

Dan, I have seen the same type of behaviour too with ATI 2021 and consider this another of the unexpected design behaviours in the new version but fortunately it doesn't seem to cause any issues.

The only update currently available for 2021 is build #30480 but I would expect there to be further builds due to the number of potentially critical issues being reported for this version!

Thanks for update & acknowledgement problem known.

As Steve said, there will be (I suspect) multiple new build released in the coming months to "correct" the many bugs in the code (mostly in the new Protection module which is badly broken - it was far less broken in the beta versions I ran). Unfortunately, there is no way of knowing when the next build will be released or what ills it will address.

Ian

frestogaslorastaswastavewroviwroclolacorashibushurutraciwrubrishabenichikucrijorejenufrilomuwrigaslowrikejawrachosleratiswurelaseriprouobrunoviswosuthitribrepakotritopislivadrauibretisetewrapenuwrapi
Posts: 250
Comments: 7092

Hello Dan,

could you please check if the issue persists on the new build 32010?

Ekaterina, I have just had to try to Stop a backup on one of my VM Windows 10 machines with exactly this issue doing a backup after updating to 32010, where it got to less than 1 minute then has gone back to the beginning and calculating time!

That VM is now stuck with 'Processing' spinning a circle on a blurred ATI 2021 GUI panel when I am trying to shutdown and go to bed!

Just extra confirmation, should it be needed, that this issue still exists in build 32010. For me it only went back to 'Backing Up' with the progress bar indicating the start of the backup, continuing to 'Validating' after a short time.