failed to read from sector '0' on hard disk '1'

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 0

Hi,

 

I'm quite newbie to RAID & SAS and trying to work with both :)

 

So I have 2 Seagate SAS SSDs (1200.2) connected to LSI 9217 4i4e SAS Controller.

in the LSI utility I can't create a RAID0 volume rom the both of them. Trying to format them from the LSI utility fails as well.

 

In windows 10 I can see both disks but I can't initialize them nor format them.

When Using Seagate DiscWizard I get this error message from the subject.

Both smarmontool and SeaTools for windows show these disks are working properly.

They were pulled out from a server if that helps...

 

I don't know how I can initialize/format or any other needed action in order to get them available in Windows 10.

 

Would appreciate any help :)

Sun, 07/04/2021 - 20:03
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Member
Posts: 24
Comments: 57

It's possible that the drives are locked.

See section 6 of 1200-2-sas-ssd-product-manual-100773817d.pdf from Seagate's site.

Not sure what procedure or tool you'd need to use to unlock them or simply factory restore them.  Try asking Seagate.

Tue, 07/06/2021 - 21:37