Acronis True Image 11 Home Errormessage after backup and validation

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 0

Hello,
after Backup and Validation i get an Errormessage with a crypted error code

0x0064008A+0x000101F6+0x00070020

checked in the errorcode Faq - no result. I can open the Backupfile via Windows Explorer and surf through the backup, but is it corrupted or not?

Thanks for your help

Franz

Fri, 12/28/2012 - 18:19
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 0
Comments: 2

Hi Baba, I had the same problem with ATIH2013 that was caused by a defective RAM module, I suggest you to test RAM extensively (I used MemTest 86+ v. 4.20) and if you get error to replace it as I did and now restore & validation are working fine.
Good luck
.

Sat, 02/23/2013 - 14:02