Skip to main content

Acronis UEFI Boot Loader hangs

Thread needs solution

I am using the Windows 7 UEFI Boot Loader running off two Corsair SSDs in RAID 1 mode off an Intel Raid Controller.

I have been trying to "Add a Disk" to Windows 7 (64-bit) and it states a reboot is required. So, I immediately reboot the computer and the Acronis UEFI loader attempts to boot and hangs. I have also attempted to perform a system restore, which is also not working because it also requires the Acronis UEFI boot loader to run ... but once again it hangs.

What is needed to get the Acronis UEFI Boot Loader working, since just about any disk operation requires this? Would the Plus Pack fix the issue?

0 Users found this helpful

Do any operation that requires a reboot from the Acronis recovery CD: add disk, recovery, clone. It is not because of UEFI, it is recommended practice with ATI forever for multiple reasons.