ATI 2011 Power Pack Creation fails
I just finished creating the boot disk for Power Pack Plus -- but it won't boot.
No errors while creating, but I get an error that snapman.sys is missing or corrupted.
So now what do I do to fix this? Is it just "faulty disk writing"? If so, why didn't I get any error message during the process? Unless I know what the heck happened, I can't know that it is fixed.
Chuck Billow

- Log in to post comments

Grover, why didn't the "Help" say just that...as you did? Would've saved me a couple hours trying to find the missing file, figure out what to do, fall on my butt half a dozen times...
Then they could have said: "But for tose of you that like things the hard way, here you go:...."
Silly me...
Thanks,
Chuck
- Log in to post comments

You learn better if you have experienced the situation.
- Log in to post comments

I don't get where the "snapman.sys" error came from. TI doesn't use that on the CD so it wouldn't be part of the building process. It also woudn't affect the booting of the CD. Was this error from installing the PP?
- Log in to post comments