ATI 2011 Try & Decide Questions

I just tested Try & Decide TI2011 on my Intel RAID 0 and multi-boot system (7 OS with Windows boot menu created with the help of EasyBCD). I just started and stopped Try & Decide and had to reboot to discard changes. It ended in an endless loop when it tried to start the Acronis loader - not a real boot loop but just messages with starting Acronis loader one message after the other on the same screen. There was no way to stop this and get out. At a restart with power off/power on I just got there again. Good that I had a partition backup created before the test and that I had the Acronis rescue disk.

Since this RAID 0 holds some TB of data and 7 OS versions it is not easy to rebuild. So before I continue with Try & Decide tests I would like to know if there are any known problems in a multi-boot environment or with an Intel RAID 0 system. If so there is no need to continue. I do not want to play too much around on this big system. I just had to rebuild it because of a broken disk in this RAID setup - took me very many hours despite good backups :-(

I tested Try & Decide with TI2013 on a single disk system with a single OS before. It worked without problems. But on my big system with TI2011 RAID 0 and multi-boot it was a different story as written before.