Skip to main content

ATI 2011 validation takes forever - or does it?

Thread needs solution

Just done a full backup of about 55GB.

The validation stage started with an indicated 'less than one minute' duration, which then changed after about 30 seconds to 22498 days 12 hours 19 minutes. This rose to a maximum of 23980 days then reduced to a minimum of 19999 days before rising again to 23461 days.

What's going on?

Why no space for comments like 2010?

0 Users found this helpful

Same here the validation duration is not accurate same happened in TI2010.

I'm too missing the comments which I could use in TI2010.

It seems Acronis has dropped same good features out of TI2011 with no replacement at all. They should have asked the users/customers before cutting thins out of TI. I hoped to get a better TI with this new release, so far its a step back...

cu,
Michael

There is a thread about this problem here

The validations do eventually finish much sooner than 210 years or so.

Hello all,

Thank you very much for your comments.

We just released a new build and the validation issue has been successfully resolved.

I would like to lock this topic so that any issues can be discussed in the main topic. This will really help us if we keep discussing this problem in one place.

Please check this link for the main topic and my announcement in it.

Thank you.