Best form of backup: clone vs one click & ease of use of restoring to diss. hardware
Hello. I want to thank everyone responsible for setting up this forum. I also want to thank those knowledgeable persons who help people by answering their questions.
I purchased Acronis Home 2011 with the additional plus pack. My initial intention was to clone my primary hard drive (3.5 inch SATA in desktop) approximately once per month. If my primary hard drive went down, I would just replace it with the clone. With the addition of the plus pack, I thought that if I had a catastrophic computer failure I could place my cloned harddrive into another PC and have the same environment as that provided by my primary hard drive. The clone was going to be a similar 3.5 inch SATA but in an external hard drive enclosure attached to the PC via a USB cable.
However, after reading the Help file, it seems to me that the 'One-Click Backup' is essentially the same thing as cloning. Is this correct?
My computer does not like booting from USB, so if the primary fails I have to physically replace it in order to boot the computer. Is there any difference between the 'One-Click-Backup' left with the defaults set to once per month and just cloning once per month?
If I use the 'Rescue Media Builder', which is where the 'Home 2011 Plus Pack' seems to be mainly incorporated, do I still need to search for drivers if installing to dissimilar hardware? Is there anyone who has restored to dissimilar hardware without providing specific drivers for their new environment and just provided the drivers at a later date once the system was up and running?
In the worst case scenario where I have to install to dissimilar hardware, do I only need the bootable media made from the Plus Pack and the appropriate drivers for the new hardware?
I apologise if these questions have been answered before, or are answered in the Help file, but right now I feel like my head is plitting with information overload and I don't know if I can read any more of the help file without getting more confused as this point.
Yours respectfully,
ChocolateBurmese
- Log in to post comments
Thank you Pat for your reply. Just a few more questions if you have the time and inclination to answer:
If I physically replace a primary hardrive with a drive backed up with the scheme you mentioned above, will it work just the same as replacing a primary drive with a relatively recently cloned drive? (of course I understand that 'relatively' depends on the frequency of backups)
If I don't use the incremental backup scheme you mentioned above, but instead use the one click feature and schedule full backups once per month as per the default backup scheme, would then replacing the primary drive with that drive work the same as replacing it with a relatively recently cloned drive?
Thanks in advance
Choc.
- Log in to post comments
Yes, if you have a full disk (ie all partitions) backup, you will be able to put a new drive in your computer and restore to the point of backup, exactly.
Yes, make sure that the one-click backup is including all the partitions of your system disk (including those that are hidden, but that ATI sees when you start a disk and partition backup setup). With this, you are also good to go.
Also remember to create a CD, and actually boot your computer with the CD. Try to restore a couple of files. Just to make sure, you know, that you can do it when you need it.
- Log in to post comments
Thanks Pat! That cleared a few things up and I am relieved to know that I can do what I want easily.
Thanks again.
Choc.
- Log in to post comments