Skip to main content

Boot True Image into command line?

Thread needs solution

I try to boot via Acronis True Image 2013/2014, but always enter into a messed screen. I have tried the solution at https://forum.acronis.com/forum/89391 to set the vga=ask or vga=0x301, etc., all do not work.

Therefore, I just wonder if it is possible to just boot True image and enter into a command line interface instead of GUI, and perform all the recovery tasks via commandline, that will solve the problem.

Thanks

0 Users found this helpful

No, that's not possible. when you make the boot disk you have the option to set some parameters.

These are about the only command line parameters that be used and they have to be included when the rescue media is being created. 

http://www.acronis.com/en-us/support/documentation/ATI2016/#3425.html