Skip to main content

Build 5519 for TI 2011 and Validation Timing

Thread needs solution

This thread has been locked so starting a new one on the same subject as it does not seem to be resolved correctly in the new build 5519.

http://forum.acronis.com/forum/14322

The fix for the validation timing is still not correct because:

The backup progress bar gets to approx 90% and then says less than 1 minute to go. It then changes to Validating but the less than 1 minute to go is not replaced and stays until the end of the task. The validation takes longer than 1 minute to complete from what I can see as the log reports that is took at least four minutes and the backup itself took just two so I fail to see how 2 minutes = 90% of the progress bar and four minutes takes the final 10%.

OK we do not get silly numbers presented but this is hardly a fix.

0 Users found this helpful