Can't add additional incremental Backup to my backupset

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Member
Posts: 7
Comments: 47

Hi,
i am using True Image 2013. I have a File-Backup of my Drive D, which consists of one full and one incremental backup. Now i want to add an incremental backup again.
But when selecting the backup in the list of "Backup and Recovery", i do not see an button "Backup now". So how do i start the backup ?????

I did have that issue already, when creating the first incremental part. I have written down, that at that time, i was able to get the button, by right-clicking on the backup, then clicking on "Backup-einstellungen erneut erstellen" (englisch: Re-create the Backup-Settings), and then using the backup-now button on the end of that page. But this one is also greyed out this time.

Help would be very appriciated.

Thanks in advance

Thu, 12/11/2014 - 14:30
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Member
Posts: 7
Comments: 47

Have found the solution:
With right-mouse click on that backup-set i did have to recreate the backup-settings.
In these settings, even the drive which has to be backuped was not selected.
Seems as if the only fact the system did remember was the setting "one-full all others incremental"-Type of Backup. All other settings, which drive, which exclusions and so on had to be set again.

The missing drive-letter was the bad point which disabled the Backup-Now-buttons.
After that everything seemed to run ok.

Fri, 12/12/2014 - 16:18