Can't recover backup using Rescue Cd
I can not recover my backup .tib file when I use the Rescue Boot CD (it hangs up near the end of the recovery) but everything works when I slave the destination drive to another master drive and do the recovery in Windows. Also, one of the partitions on the backed up file has a Truecrypt container on it, but I don’t know whether or not that matters ??
Anyone have any idea why the recovery doesn’t complete with the boot cd ? I’m using XP Pro and ATIH 10.
Thanks in advance -

- Log in to post comments

Hello,
I have the problem where usb drives are not detected using a boot disk on true image 10.
have downloaded the iso and booted .. get acronis logo ans " loading please wait " hangs at this point.
remove usb drive and still the same.
Trying to recover
Laptop ..Packard bell easy note model number r1938. has via chipset
suggestions please .
terry
- Log in to post comments

Terry - are you using a wireless mouse or keyboard by any chance?
- Log in to post comments


Well, some folks do use a mouse or KB with a laptop - just trying to see if there was an simple hardware issue why the loader hangs. The hardware is checked after the loading, please wait message. Sometime setting acpi=off helps.
- Log in to post comments

Hi Gary,
Thanks for the help, the bios is locked down so unable to to acpi = off .
You do mean in the bios , or have |I got it wrong ?
terry
- Log in to post comments

Hello,
Gary, thank you very much for you help.
Terry, you don't need to change anything in BIOS settings.
To boot of from the CD with 'acpi=off noapic' parameters please do the following:
- boot the computer from Acronis bootable rescue CD (with ISOLINUX loader)
- Hit the ESC key when ISOLINUX word appears. (This should happen before loading ramdisk.dat and kernel.dat).
- You will get the boot: prompt. In the prompt type all the necessary parameters as shown below:
kernel.dat initrd=ramdisk.dat vga=0x314 quiet acpi=off noapic
Please reply to this thread if you need any further assistance.
Thank you.
- Log in to post comments