Child process exited with code "0"
One of my backups appeared to stop during the Validation, with the Log entry : Child process exited with Code "0"
The Back up was initiated by a Win Task Schedule action, with a setting "stop the Task if it runs longer than 4-hours."
Whilst the Task should have been completed in less than 4-hours, the log entry was 6 hours after the start of the validation and was when PC was manually woken.....the PC shouldn't have gone into sleep mode in the first place.
Any clues as to the cause and meaning of the error message?
I have extended the Task setting, ought I to switch the power saving "sleep" mode to manual, as well?
Regards....Noel
- Log in to post comments
Many thanks GroverH.
I use a Post Command to close down the PC following the final Backup. When I first installed TI2014, I simply put the Sleep facility under manual control. I think I'll return to this setting.
Regards and thank you again......Noel
- Log in to post comments
I believe the child process of 0 is referring to your post command. Is the post command a batch or command file? If it is simply a shutdown command. I would suggest it be put into a batch file for execution via the post command.
- Log in to post comments
As usual, many thanks GroverH....
....as usual, you are right. The shutdown command script is in the "Post command."
I have saved the script in a BAT file, making that the "Post command" entry.
As recommended, I have created a Shortcut to stop the close down! Very convenient.
I don't know what users and for that matter Acronis would do without your help GroverH!
Regards and many thanks.....Noel
- Log in to post comments
.....crikey, even the Forum website is hiccuping now!
.....Noel
- Log in to post comments