Fail to read default
Can I change this default to "Ignore All"?
<?xml version="1.0" encoding="UTF-8" ?>
Create Full Backup Archive</bold><endl/><tabpoint value=30><indent value=4>From: <indent value=10><textcolor value="navyblue">Disk 1</textcolor></indent><indent value=4><endl/>To file: <indent value=10><textcolor value="navyblue">"D:\System_C_@date@.tib"</textcolor></indent><indent value=4><endl/>Compression: <indent value=10><textcolor value="navyblue">None</textcolor></indent><indent value=4><endl/></indent><endl/>" module="11" time="1367456904" />
Read error (0x70003)
Tag = 0xDF81DA2C74EC501E
Failed to read the snapshot. (0x10C45A)
Tag = 0x14181C22EF45AD6D
CRC error (0x100155)
Tag = 0x2AACB7B2AB852AF</indent>" module="1" time="1367466607">
- Log in to post comments
You need to find out why True Image is not able to make a snapshot. Does the task complete if you select ignore?
- Log in to post comments
Thanks for the response, Colin.
Yes. If I'm at the computer, the question usually arrives about two hours into the back up. If I manually choose "ignore", the back up will continue successfully. The seemingly endless wait for the error is annoying and it has a ten minute timeout when it will default to cancel operation. That's why I hoped it could default to "ignore". Obviously, I don't know why or how to diagnose the original problem activating the error. I ignore bad sectors, which I believe there a couple.
- Log in to post comments
Run chkdsk /r on all your disks including the one you are imaging to, this will fix any logical bad sectors on your drive.
I'm not sure that setting TI to 'ignore all' is wise, I'm also not sure that selecting that will prevent TI from stopping. If you are sure you have a valid complete disk image, select it and see what happens.
It might not be a disk problem but one of failing RAM, so I would suggest running Memtest86 overnight just to check.
- Log in to post comments