Failed to read data from disk
I get this error for at lease 90 consecutive sectors. Ran CHKDSK /r several timesl no error reported. Ran "REPAIR" from installation file; no change. See attached for the identification of one of those sectors.
How do I get this fixed?
| Attachment | Size |
|---|---|
| picture0003.png | 10.76 KB |
- Log in to post comments
Hi David,
Do you have more than one partition on this disk???
- Log in to post comments
Run chkdsk on the other partition as well. chkdsk /f [x:] where x is the drive letter you assigned to the other partition
- Log in to post comments
Performed "chkdsk /r" on both partitions; result is the same
- Log in to post comments
That error is indicative of a failing hard drive. Download and run the drive manufacturers diagnostic utility.
- Log in to post comments
Drive manufacturer diagnostics report drive is error free!
- Log in to post comments
David,
Almost missed the part of your post where you said you were using the latest build of 2012_7133.
There was a problem with the SnapApi in the earliest builds of 2012. I think #5545. If you have been upgrading over the top of previous versions a problem could have developed. Since the disk has tested ok, I'd uninstall and reinstall ATI.
Using the clean tool may be wise. Be sure you follow the instructions completely.
Before you do that, have you tried performing this operation from a BOOT CD?
- Log in to post comments