Skip to main content

Failed to read snapshot (0x10c45A) RCR error (0x100155)

Thread needs solution

Hi,
I am getting an error Failed to read snapshot (0x10c45A) RCR error (0x100155). It was working good on the last BackUp.
I have searched the internet and did the check disk had found no errors and the SnapAPI update. Still has the same error.
What else can I try.
This is very frustrating and wasting my time looking.

Thanks BBryan

0 Users found this helpful

You can try setting Windows VSS to run Automatically and see if that helps. Using Windows search type services.msc, open as admin, scroll through resulting list to find VSS service, highlight then right click and choose properties, select Auto Start.

If that fails you can try to temporarily set VSS to disable prior to running the backup task using the same procedure as above. Remember to re-enable VSS when finished.

Thanks Enchantech,
I was just in the services.msc and I dont see a listing called VSS or windows VSS. Would it be called something else.

Thanks BBryan

VSS (Volume Shadow copy Service). Included in Win XP service pack 2 and later using NTFS filesystem.

Thanks Enchantech,
Ok I see that there. I am running windows 8.1
It says manual and running
I tried too right click but there is no option for Automatic. There is just stop and a greyed out start. I stoped it and then restarted.
I tried again to run the backUp and it still gives the error. If I click ignore all It will run the whole backup.
After this backUp was done I ran the validate the back up it says validation has failed.
Any thoughts on this.

Thanks Bryan

Click on Volume Shadow Copy to select it then, right click and in resulting menu select properties, you should find Startup type having a drop down box from which you can choose the various options.

Hi Enchantech,
Sorry I was gone for a few days...
Thanks I found it.....
Ok I selected Automatic I am going to try tonight again. I don't have enough time to do it at work today

Thanks BBryan