Skip to main content

Image 2014 Kein Klonen nach Windows Neustart

Thread needs solution

Hallo

Ich benutze A. Image 2014 auf Laptop mit  Windows 10. Klonen einer Festplatte ausgesucht und Neustart-Anfrage bestätigt. Nach dem Neustart macht Windows normal wieter als wäre nichts geschehen. Acronis arbeitet nicht weiter.

Was kann ich machen.

MfG

0 Users found this helpful

Egon wrote:

I use A. Image 2014 Laptop with Windows 10. Cloning a disk selected and confirmed restart request. After restarting Windows makes normal wieter as if nothing happened. Acronis stops working.

What can I do.

ATIH 2014 is not supported for use with Windows 10.

It is also not recommended to start a clone from within Windows as this can corrupt the Windows BCD boot loader information.

Please try using the ATIH 2014 bootable rescue media - and check that when Acronis is launched that you can 'see' both disk drives that you want to clone from and to, to ensure that the media actually supports the hardware devices you are using here.

The recommended method of performing a clone is to replace the current boot drive (source drive) with the new boot drive (clone target) and then connect the original boot drive to the laptop by USB.  Boot from the rescue CD or USB stick, then clone from the source drive to the new target drive.

Once complete, shutdown and remove the original external drive before attempting to boot from the new cloned internal drive.

See KB document: 2931: Cloning Laptop Hard Disk which has a video demonstration of cloning a laptop drive.

Hi

Thanks for your suggestion. But i did always clone a drive like this before. The problem is new. I don't want to repleace but only secure the drive , for example with windows so i must no going to the prcess of installing thausends of features again when i got a virus or something.

I go your way, lets see.

Soory for the bad english.

MfG