Monitor timing error using OEM build 10045 boot CD

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 3
Comments: 3

One of our customers is trying to use the Acronis boot disk (build 10045) and gets a timing error as shown on attachment and then can't go any further.
The same boot disk on the same computer worked with another monitor here at the factory.
Is there a fix/workaround for this?

Attachment Size
IMG_0802.jpg 208.25 KB
Wed, 08/04/2010 - 21:18
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 3
Comments: 3

Update: this appears to be due the use of a low grade VGA extension cable and the fact that Acronis was using a high enough screen resolution that the monitor could not sync. Problem solved by using a high grade cable. A short term workaround was to use vga= command line to specify a lower resolution for Acronis (use F11 key after bootup screen).

Attachment Size
39218-91111.jpg 159.89 KB
Thu, 08/05/2010 - 17:12